Device Setup for Left or Right

Release From

Early SW1s had spring stops that could be swapped from side to side. The device was initially configured to start a measurement with the front of the cradle held to the left (clockwise from the top) prior to releasing it, but it can be configured to release from either side.

To reconfigure:

  1. Disengage the spring.
  2. Remove the retention clips above both spring stops.
  3. Remove the spring stops, flip them over, and reinstall them on the other posts.
  4. Reinstall the retention clips.
  5. Re-engage the spring.
  6. In the app, navigate to the Settings page and update the Release from value.

Phone Mount

The phone can be placed on either side of the cradle. The cradle strap is initially configured to avoid interfering with a phone placed on the left side, but the strap can be removed and reinstalled in the opposite direction.

Back⏎