Tare Button

The Tare button in the upper-right corner of the Measure page can be used to subtract the value of a mounted adapter or target racquet. To set the tare value, take a measurement that you would like to become the new zero, and tap the Tare button. The button will display filled to indicate that it is active, and the last measurement value will change to zero. Subsequent measurements will be displayed with the tare value subratracted. Tap the Tare button again to clear it.

Stored Tare Values

The last three rare values are stored for re-use. This is useful when repeatedly switching to an adapter or between adapters. To select a prior tare value, long-press the Tare button and then tap on the desired tare value. Note that calibration deletes stored tare values.

The tare values will persist when the app is restarted, and if you have more than one SW1, they are stored by device.

No Effect on Prior Measurements

Measurements shown in the Measurement Groups section will reflect the tare value when the measurement was taken. Prior measurements will not be affected.