How Do I Level the SW1?

Reset the Feet with the Rear Higher than the Front

  1. Set the rear leveling foot about 3 mm (1/8") out from the base.
  2. Set both front leveling feet about 1 mm (a bit under 1/16") out from the base.
  3. Place the cradle near to the left stop and release it. The cradle should swing to the front. If not, raise the rear foot and repeat until it does.
  4. Repeat step 3 near the right stop.

Adjust Right-to-Left Level

  1. Place the cradle in the middle and release it. If the cradle swings one direction, raise that side and repeat until it will settle in the middle.

Adjust Front-to-Rear Level and Fine-Tune

  1. Lower the rear foot all the way to the base.
  2. Place the cradle against either stop and release it. It should rest against the stop.
  3. Raise the rear foot until the cradle just begins to move away from the stop.
  4. The device should now be nearly level. Verify that the cradle remains nearly stationary when released in any position, and if not, fine-tune the leveling feet until it does.
Back⏎